Wayne-Dalton 9600 installation instructions Attaching Disconnect Handle

28	Attaching Disconnect Handle
Tools Needed:	NOTE: See idrive® main installation and
Phillips head	owners manual for idrive® parts.	Upper Position
screwdriver	Note: Bring motor to the down position	#6-20 x 1/2”
Wire cutters	by pulling the disconnect cable, insure
		Screw
	opener disconnect teeth are engaged
	before installing disconnect handle.
	Start the #6-20 x 1/2" screw into the
	disconnect handle. Thread the
	disconnect cable through the top of the
	disconnect handle bracket and then the	Handle
	disconnect handle.
	Locate the disconnect handle in full
	upper position of disconnect handle			INSTALLATION
	bracket.
	Remove all disconnect cable slack	Disconnect	Emergency Disconnect
	between the opener and the top of the	Cable	Label
	disconnect handle bracket. Tighten
	#6-20 x 1/2" screw into the disconnect
	handle until snug, and then tighten
	screw an additional 1 to 1-1/2 turns to	Disconnect
	secure disconnect cable to the
	disconnect handle. Trim off excess cable	Handle
		Bracket
	from bottom of the disconnect handle.
		Manual operated position	Motor operated position
	CAUTION: Pull Cable only taut
	enough to remove the Cable slack.
	Pulling the Cable more could
	cause Opener to disconnect from
	the TorqueMaster® Spring tube.
	Apply emergency disconnect label next
	to the mounted bracket. Use
	mechanical fasteners if adhesive will
	not adhere.
	Using the emergency disconnect, pull
	disconnect handle downwards and
	place it in the manual door operated
	position (Use disconnect label for
	reference). Motor will be rotated 90°
	from its packaged position.
	If motor does not pivot 90°, see
	troubleshooting section in the main
	installation and owners manual of your
	idrive® opener
				27

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com