Cub Cadet 3184 B. Installation of Mower Deck, Front Caster Wheel Rear Gauge Wheel Upper Hole

Quick Latch Rod	Latch Receiver
	Slots

Front Lift

Bracket/Rod Ass’y.

Figure 39

9.From the left side of the tractor, slide the mower deck out from under the tractor.

B. Installation of Mower Deck

NOTE: The LH lift link must be raised to provide clearance for sliding the mower deck under, or out from under, the tractor.

1. If not already done, lock the LH lift
	link in its deck installation/removal
	position	as	follows:	(Refer	to
	Figures 36A through 36D).
•	Holding the LH lift rod downward,
	lift upward on the release tab of
	the lift stop bracket while raising
	the rearward end of the lift link to
	align its slot with the notch of the
	LH lift rod (See Figures 36A and
	36B).
•	Swing the LH lift rod forward until
	fully to the front of the lift link slot
	(See Figures 36C and 36D).
2. Start the tractor and use					the
	hydraulic lift to fully raise the left
	lift link. Stop engine.
3. Check		the	caster	wheel	and
	gauge wheel settings on the deck.
	If necessary, remove the hex cap

Front Caster Wheel

Rear Gauge Wheel Upper Hole

Figure 40

4.From the left side of the tractor, slide the deck under the tractor until the slots of the LH and RH rear deck brackets align approxi- mately with the tractor lift links (See Figure 41).

5.Pull outward and cock the deck support pins in the rear deck brackets so that both spring- loaded pins are held in the disen- gaged position against the inner surface of the deck brackets (See Figure 41).

Rear Deck

Bracket Slot

screws and nylon lock nuts, and

Deck

Pin Locked in Disengaged

adjust the wheels to their highest

setting (lowest deck setting). See

Figure 40.

Support Pin

Position

Figure 41

38