EDGE Tech Edge 540 INSTALLING THE AILERON SERVOS.

EDGE 540. Instruction Manual.
7
 5) Turn the vertical fin panel over and deflect
the rudder in the opposite direction from the
opposite side. Apply thin C/A glue to each
hinge, making sure that the C/A penetrates into
the rudder and fuselage panel.
 6) Using C/A remover/debonder and a paper
towel, remove any excess C/A glue that may
have accumulated on the fuselage or in the
rudder hinge area.
Note:Work the rudder left and right several
times to “work in” the hinges and check
for proper movement.
INSTALLING THE AILERON SERVOS.
Attach the string to the servo lead and
carefully thread it though the wing. Once you
have thread the lead throught the wing, remove
the string so it can use for the other servo
lead. Tape the servo lead to the wing to prevent
it from falling back into the wing.
We recommended to use long servos
arm for all servos without throttle servo.
Because the size of servos differ, you
may need to adjust the size of the precut
opening in the mount. The notch in the
sides of the mount allow the servo lead to
pass through.
Install the rubber grommets and brass
collets onto the aileron servo. Test fit the servo
into the aileron servo mount.
Install the servo into the servo tray.
Using a small weight (Weighted fuel pick-up
works well) and thread, feed the string through
the wing as indicated.
Secure the servos with the screws pro-
vided with your radio system.
Servo.
Small weight.
Thread.
C/A glue.
Wing bottom.
Thread.
Small weight.
Thread. Small weight.