EDGE Tech Edge 540 - page 20

EDGE 540. Instruction Manual.
20
MOUNTING THE TAIL WHEEL BRACKET.
MOUNTING THE CONTROL CLASP.
See pictures below:
 1) Set the tail wheel assembly in place on
the plywood plate. The pivot point of the tail
wheel wire should be even with the rudder
hinge line and the tail wheel bracket should
be centered on the plywood plate.
 2 Using a pen, mark the locations of the
two mounting screws. Remove the tail wheel
bracket and drill 1mm pilot holes at the loca-
tions marked.
 3) Secure the tail wheel bracket in place
using two 3mm x 12mm wood screws. Be
careful not to overtighten the screws.
INSTALLING TAIL STRUT SYSTEM.
Tail strut system assembly follow pictures
below.
Control clasp.
2 screws.
2mm X 20mm.
3.2mm drill bit.
Right side.