EDGE 540. | Instruction Manual. |
|
|
ELEVATOR - RUDDER SERVO
INSTALLATION.
1)Locate and cut out the covering film from the servo holes in both sides of fuselage.
Remove covering.
2)Install the rubber grommets and brass collets onto the elevator and rudder servo. Test fit the servo into the aileron servo mount.
Because the size of servos differ, you may need to adjust the size of the precut opening in the mount. The notch in the sides of the mount allow the servo lead to pass through.
3)Secure the servos with the screws pro- vided with your radio system.
Left side.
Elevator servo.
Right side.
Elevator | Rudder servo. |
servo. |
HORIZONTAL STABILIZER.
1)Using a ruler and a pen, locate the centerline of the horizontal stabilizer, at the trail- ing edge, and place a mark. Use a triangle and extend this mark, from back to front, across the top of the stabilizer. Also extend this mark down the back of the trailing edge of the stabilizer.
16
Center line. 
2)Using a modeling knife, carefully re- move the covering at mounting slot of horizon- tal stabilizer ( both side of fuselage).
Remove covering.
3)Slide the stabilizer into place in the pre- cut slot in the rear of the fuselage. The stabi- lizer should be pushed firmly against the front of the slot.
4)With the stabilizer held firmly in place, use a pen and draw lines onto the stabilizer where it and the fuselage sides meet. Do this on both the right and left sides and top and bottom of the stabilizer.
Pen.
5)Remove the stabilizer. Using the lines you just drew as a guide, carefully remove the covering from between them using a model- ing knife.
