EDGE Tech Edge 540 specifications Wheel and Wheel Pants

EDGE 540. Instruction Manual.

125mm. 4mm X 30mm.

2)Place your engine onto the engine mount. Adjust the engine is centered of the edges of the engine case.

3)When you are satisfied with the align- ment, mark the locations of the engine mounting.

4)Remove the engine. Using an drill bit, drill the mounting holes through the engine mount at the four locations marked.

4.2mm (4 pcs).

5)Bolt the engine to the engine mount using the four machine screws. Double cheek that all the screws are tight before proceeding.

6)Attach the Z-Bend in the pushrod wire to the throttle arm on the carburetor. You will need to remove the throttle arm from the car- buretor to be able to attach the Z-bend. When complete, reattach the throttle arm to the car- buretor.

12

Pushrod wire.

WHEEL AND WHEEL PANTS.

1)Assemble and mounting the wheel pants as shown in the following pictures.