PROBLEM |
| POSSIBLE CAUSE |
| SOLUTION |
|
|
| ||
Bucket or Boom Leaks | • Leaks in hydraulic circuits | • Tighten loose fittings. Use | ||
Down from “Hold” |
|
|
| thread sealer on pipe threads. |
Position | • Cylinder piston seals leaking | • Repair (if available) or replace. | ||
| ||||
| • Remote valve worn or damaged | • | Repair. | |
| • Tractor valve worn or damaged | • | Repair. | |
|
|
|
| |
Cannot Lower Boom | • Hydraulic couplers not fully engaged. | • | Recouple hoses. | |
|
|
| ||
Loss of Bucket Tilt | • Tractor lever in “Float” position | • Shift control lever from “Float” | ||
Control When Lever |
|
|
| position. |
is Pushed Completely |
|
|
|
|
Forward |
|
|
|
|
|
|
|
| |
Couplers Hard | • | Pressure in circuit | • Place control levers in “Float” | |
to Hook Up |
|
|
| when connecting. |
|
|
|
| |
Boom & Bucket | • Improperly installed hydraulic couplers | • | Install hydraulic couplers | |
Operation Does Not |
|
|
| correctly. |
Correspond To Control | • | Hoses improperly connected | • | Connect hoses properly. |
Lever Position |
|
|
|
|
|
|
| ||
Excessive Wear on | • Bucket is tilted too far forward and is riding | • Keep bottom of bucket parallel | ||
Bucket Cutting Edge |
| on cutting edge. |
| to ground. |
and Wear Pads | • Excessive down pressure when cleaning | • Use “Float” position on boom | ||
| ||||
|
| feedlots and working on concrete. |
| lift control lever. |
|
|
|
|
|
25
