Cub Cadet 7252 Head Light Bulb Replacement, Tail Light Bulb Replacement, Hazard Bulb Replacement

HEAD LIGHT BULB REPLACEMENT

The tractor is equipped with four headlight bulbs. If one of the bulbs should burn out, replace the bulb as follows:

•Fully raise the hood so that the hood prop link holds the hood in the raised position.

•Pull both locking tabs of the wire harness plug away from the bulb/socket assembly and unplug the wire harness from the bulb assembly. See Figure 34.

BULB/SOCKET

ASSEMBLY.

WIRE	REFLECTOR
HARNESS
PLUG	LOCKING TAB

Figure 34

•Turn the bulb/socket assembly approximately a quarter turn counterclockwise to align its tabs with the notches of the reflector, then remove from the reflector.

•Replace with a new bulb/socket assembly (Cub Cadet No. 725-3161A).

•Align the tabs of the new bulb/socket assembly with the notches of the reflector and insert the bulb.

•Turn the bulb/socket assembly clockwise to lock in place. Plug the wire harness into the socket, making sure the plug locking tabs lock onto the socket assembly.

TAIL LIGHT BULB REPLACEMENT

Each tail light assembly has two light bulbs — a reverse indicator bulb (Cub Cadet no. 725-3263) and a tail light (Cub Cadet no. 725-3262). Access the back side of the tail lights from under the rear fender.

NOTE: Use caution when removing the tail light sockets from the reflector housings. The bulbs can be pulled from the sockets and dropped into the reflector housing, requiring removal of the reflector housing to retrieve the bulb.

Replace a tail light bulb as follows:

•Turn the light socket counterclockwise to align the socket tabs with the notches in the tail light reflector.

•Once aligned, carefully pull the light socket out of the tail light reflector.

•Pull the light bulb from the socket and replace with a like part.

•Align the tabs of the socket with the notches in the reflector and carefully insert the socket. Turn the socket fully clockwise to lock in place.

HAZARD BULB REPLACEMENT

Flashing hazard lights are installed on each side of the ROPS. Replace the bulbs as follows:

•Grasp the outer half of the light housing and both the front and rear lenses. Accessing the screws from the notches at the top and bottom of the outer housing, remove the two screws fastening the outer and inner housings together. See Figure 35.

NOTCH	LENSES
	BULB	SOCKET
SCREW

INNER

NOTCH HOUSING

OUTER

HOUSING

Figure 35

•Remove the outer housing and lenses.

•Push in on the bulb and turn counterclockwise to remove the bulb from the light socket.

•Align the new bulb with the socket slot, push the bulb into the socket, and turn clockwise to lock it in the socket.

•While making certain the lenses engage the front and rear grooves of the inner housing, install the lenses and outer housing. Secure with the two screws.

31