Thermador Comprehensive Guide for Installing Grease Trays and Filters for Ventilation Hoods

Installing Grease Trays, Filters and Spacers

1.Remove all plastic from hood pieces.

2.Insert in the following order:

1)Grease Tray — Push up and in over the rear lip.

2)Filters — Slide filter over the front lip. Push filter rear up, then slide back over rear lip. Depending upon the size and model of hood, there will be from 1 to 3 filters per hood.

3)Filter Spacer — Insert these the same way as the filters.

2	2	Data Rating
1
	1	Plate

Figure 27: Heat Lamp Replacement

Halogen Light Replacement

Filter

Filter

Spacer

Spacer

Grease Filters

Tray

Bulb

Lens

Figure 26: Hood and Parts

3.Reverse the above directions to remove the grease tray, filters and filter spacer (Figure 26).

Note:

Do not use cooktop while hood is disassembled. Grease trays must be in place before installing the filters.

Heat Lamp Replacement (some models)

•Turn heat lamp clockwise to install (Figure 27).

•Replace lamp with either a PAR-38 175W heat lamp or a PAR-40 250W heat lamp.

Refer to the Use and Care Guide for additional information.

Figure 28: Halogen Light Replacement

1.Using a flat edge from a screwdriver or equivalent tool, pry loose the lens cover, as shown in Figure 28.

2.Pull damaged bulb straight out from the socket to remove.

3.Replace with a new 120 V, 40W (maximum) bulb with G-9 base. Press pins in bulb base straight into socket until fully seated. Follow package directions and do not touch new light with bare hands, the oils from your skin can reduce the longevity of the bulb.

4.Reinstall the light and cover.

English 16