Thermador PH42GS, PH54GS Important Safety Instructions, Read And Save These Instructions

Safety

IMPORTANT SAFETY INSTRUCTIONS

READ AND SAVE THESE INSTRUCTIONS

APPROVED FOR ALL RESIDENTIAL APPLIANCES FOR RESIDENTIAL USE ONLY

Before You Begin

IMPORTANT: Save these Instructions for the Local Gas Inspector’s use.

INSTALLER: Please leave these Instructions with this unit for the owner.

OWNER: Please retain these instructions for future reference.

WARNING:

If the information in this manual is not followed exactly, fire or shock may result causing property damage or personal injury.

Do not repair or replace any part of the appliance unless specifically recommended in the manuals. Improper installation, service or maintenance can cause injury or property damage or void product warranty. Refer to this manual for guidance. All other servicing should be done by a qualified technician.

CAUTION:

The unit is heavy and should be handled accordingly. Proper safety equipment such as gloves and adequate manpower of at least two people must be used in moving the hood to avoid injury and to avoid damage to the unit or the floor. Rings, watches, and any other loose items that may damage the unit or otherwise might become entangled with the unit should be removed.

Hidden surfaces may have sharp edges. Use caution when reaching behind or under appliance.

Safety Codes and Standards

This appliance complies with the following Standards:

•UL 507, Standard for the Safety of Electrical Fans

•CAN/CSA-C22.2 No. 113, Fans and Ventilators

It is the responsibility of the owner and installer to determine if additional requirements and/or standards apply to specific installations. Always refer to local codes to ensure all requirements are met.

If required by the National Electrical Code (or Canadian Electrical Code), this appliance must be installed on a separate branch circuit.

INSTALLER — show the owner the location of the circuit breaker or fuse. Mark it for easy reference.

WARNING:

Turn off power circuit at service panel and lock out panel before wiring this appliance. Requirement: 120 VAC, 60 Hz 20 A. Allow the appliance to cool after the power has been turned off before servicing the appliance.

WARNING:

To reduce the risk of fire use only metal ductwork.

CAUTION:

Vent unit to the outside of building only. This unit is only designed to be vented outside. It should not be used for recirculation mode.

Never modify or alter the construction of the appliance. For example, do not remove panels or wire covers.

English 1