Cub Cadet 7254 manual Front of Engine, Using a fuel stabilizer, Emptying the fuel system

Using a fuel stabilizer:

•Read the product manufacturer’s instructions and recommendations.

•Add to clean, fresh gasoline the correct amount of stabilizer for the capacity (approximately 6 gallons) of the fuel system.

•Fill the fuel tank with treated fuel and run the engine for 2-3 minutes to get stabilized fuel into the carburetor.

Emptying the fuel system:

•Prior to putting the tractor in storage, monitor fuel consumption with the goal of running the fuel tank empty.

•If a large volume of fuel is left-over, the fuel line can be disconnected at the fuel filter and the leftover fuel drained into an approved container.

•Run the engine until it begins to stall. Use the choke to keep the engine running until all fuel in the carburetor has been exhausted.

•Place a small container or rag beneath the carburetor bowl drain and loosen the drain screw to completely drain the fuel from the carburetor. See Figure 48.

FRONT OF ENGINE

CARBURETOR

BOWL

DRAIN

SCREW

CARBURETOR

BOWL DRAIN

LEFT VALVE

COVER

Figure 48

3.Clean the engine and the entire tractor thoroughly.

4.Drain and flush the cooling system. Refill with a minimum 50/50 antifreeze and water coolant solution. Use a higher percentage of antifreeze if the tractor will be subjected to temperatures below minus 30° F.

5.Fully charge the battery, then disconnect the negative cable at the battery to prevent possi- ble discharge. Thoroughly clean the battery. Recharge the battery periodically when in stor- age.

NOTE: Remove the battery if exposed to pro- longed periods of sub-freezing temperatures. Store in a cool, dry location where tempera- tures are above freezing.

6.Lubricate all lubrication points.

7.Jack up and block the tractor to remove the weight from the tires if stored for a long period. If not blocked up, reinflate the tires regularly.

NOTE: We do not recommend the use of a pressure washer or garden hose to clean your unit. They may cause damage to electrical components; spindles; pulleys; bearings; or the engine. The use of water will result in shortened life and reduce serviceability.

REMOVING THE TRACTOR FROM STORAGE

•Check the engine oil and coolant levels.

•Fully charge the battery and inflate the tires to the recommended pressure.

•Start the engine and allow to idle for a few minutes to ensure engine is operating properly.

•Drive the tractor without a load to make certain all the tractor systems are functioning properly.

40