Pto

SPECIFICATIONS

			Model 8404
PTO	No. or Remote control valve			2 (4 optional)
	ports
	PTO HP			33.4
	PTO shaft			SAE 1-3/8 in., 6 splines
	Revolutions	Mid PTO		2000 (@ 2,542 rpm)
		Rear PTO		540 (@ 2,451 rpm)
Minimum turning radius (without brake)				123 in. (3,125 mm)
Traction system				Swing drawbar
Weight (with ROPS)				3836 lbs.
Approx.	Forward	Low range		1.1 - 3.4 mph (1.8 - 5.5 kph)
Speed
Speed		High range		4.8 - 15.0 mph (7.7 - 24.3 kph)
(@2700 rpm
(@2700 rpm	Reverse	Low range		1.0 - 3.2 mph (1.6 - 5.1 kph)
w/Std. tires)
w/Std. tires)		High range		4.4 -13.9 mph (7.1 - 22.4 kph)
		High range		4.4 -13.9 mph (7.1 - 22.4 kph)
Tires	Ag	Front		8.0" - 16"
		Rear		13.6" - 24"
	Industrial	Front		10" x 16.5" NHS
		Rear		14.9" x 24"

Page 55

Image 55

Contents

Operator’s Manual Important Read Safety Rules and Instructions Carefully Calling Service Information Table of ContentsTo the Owner Transmission Information Recording Model and Serial Number InformationTractor Model Plate Engine Information General Operation Important Safe Operation PracticesPage Page Children Slope OperationDo not Service Safety Frame RopsOperating the PTO Page Safety Labels Safety Labels Switches and Dash Mounted Controls Controls and FeaturesIgnition Switch PTO Switch Light SwitchTurn Signal Switch Hazard Lamp Switch Hand Throttle Lever Forward/Reverse Shift LeverInstrument Panel Tachometer Hourmeter Clutch Pedal Floor Board and Fender Mounted ControlsBrake Pedals Right and Left Auxiliary Hydraulics Lever Foot ThrottleMain Shift Lever Hi-Lo Range Shift Lever Hydraulic Control Levers Differential Lock PedalBrake Pedal Lock PTO Safety Switch Seat Adjustment LeverMid PTO Lever Fueling the Tractor OperationRollover Protective Structure Rops PRE-STARTING Checks Starting the Engine NEW Tractor BREAK-IN Procedures Driving the Tractor Stopping the Engine Stopping the Tractor Driving on Slopes Turning the TractorDriving on Roadways Travel Speeds Check While Operating Using the Front Wheel Drive Using the Differential LockUsing the Position Control and Draft Control Levers Penetration w/Draft Control Only Using the MID PTOUsing the Drawbar Ground Penetration w/Draft Control and Position Surface Check Links Using the Three Point HitchTop Link Lifting Rods Tractor Weighting Using Remote Hydraulics Adjusting Front Axle AdjustmentsAdjusting the Seat Adjusting Front Wheel TOE-IN Clutch Adjustment Adjusting the FAN Belt TensionBrake Adjustment Adjusting Rear Wheel Tread Width Adjusting the Micro Switch HeightTo Adjust Checking Steering Wheel Lubrication Table MaintenanceGeneral Information Service Intervals Operation to Lubrication and Maintenance Chart Fuel System Accessing the Engine Compartment Servicing the Fuel Filter Bleeding the Fuel SystemChecking the Fuel Lines Checking the Engine Oil Level Engine OIL and OIL FilterAdding Engine Oil Changing Engine Oil and Filter Checking the Transmission Oil Level Transmission OIL and OIL FilterChanging the Transmission Oil and Filter Changing the Front Axle Oil Servicing the Front AxleChecking the Front Axle Oil Lever Adding Front Axle Oil Draining the Clutch Housing Servicing the AIR Cleaner Servicing the Cooling System Checking and Cleaning Radiator ScreenChecking and Adding Coolant Checking the Radiator Hoses Changing the CoolantLubricating the Tractor Brake pedal shaft both sides. See Figure Battery Maintenance Servicing the BatteryGeneral Battery Information Battery Removal Fuse Box Re-charging the BatteryBattery Storage Servicing the Electrical System Fuses Main Slow Blow Fuse Tire Maintenance Tractor Storage Engine Troubleshooting TroubleshootingWhen Engine is Difficult To Start When Color of Exhaust Is Especially Bad When Output Is Insufficient When Tractor Does Not Move While Engine Is Running When Engine Suddenly StopsWhen the Engine Must Be Stopped Immediately Tractor Troubleshooting Condition of Battery Cause Countermeasures Battery Troubleshooting Model Specifications PTO CLEVELAND, Ohio CUB Cadet LLC Post Office BOX

Cub Cadet 8404 manual Pto

Models: 8404

SPECIFICATIONS

Model 8404

PTO HP