3.Turn the cable collar section one or two turns to add or lesson tension on the cable. See Fig. 6-3.

Cable Collar

Figure 6-3

4.Retighten the lock nut against the cable collar. See Fig. 6-4.

End Caps

The end cap, which is used to avoid tilled soil from overflowing onto unwanted areas, are removable from the axle. Remove the hairpin clip and clevis pin that secure each end cap and slide the end caps off the axle. See Fig. 6-5.

Cotter Pin

Clevis Pin

End Cap

Figure 6-5

Hex Nut

Figure 6-4

5.With the forward and reverse tine engagement handles in neutral — released — position, pull the starter rope several times. The tines should not turn.

6.If they turn forward, adjust the forward tine engagement cable to release tension using the previous steps in this section. If the tines turn toward rear, adjust the reverse tine engagement cable to lesson the tension as with previous steps.

7.Check again for correct tension on cables.

Tines

With the outer tines installed, the working width of the machine is 24 inches. This width may be expanded to 26 inches by removing the clevis and cotter pins, sliding each outer tine outward away from the center of the unit and resecuring the pins in the holes provided. See Fig. 6-6.

Clevis Pin

Outer Tine

Cotter Pin

End Cap

Figure 6-6

14Section 6— Maintenance & Adjustments