4.Remove the hex bolt and cupped washer from the right side of the frame. Hold the cable guide bracket on the left side of frame as it will fall when the bolt is removed. Step 1 in Fig. 3–3.

1

2

3

Figure 3-3

5.Insert the handle into tiller frame as shown. Step 2 in Fig. 3–3.

6.Insert the bolt through the cupped washer, frame, handle and into the cable guide bracket (note the notch in the cable guide bracket goes over the flange on the frame.) Step 3 in Fig. 3–3.

7.Tighten the bolt securely after securing the handle brace as seen in Fig. 3–4.

Carriage Bolt

9.Insert the carriage bolt through the welded bracket on the handle, bell washer, handle brace and into the hand knob. See Fig. 3–4.

10.Select one of the three handle height positions (three notches in the welded handle bracket) and tighten the hand knob to secure the handle in the desired position. Fig. 3–4. Return to the lower handle and tighten the hex bolt securely.

Depth Gage

1.Disassemble the depth gage assembly as seen in Fig. 3–5. Retain the pin and clip for later reassembly.

Tail Bracket

Clevis

Pin

Depth

Stake

Cotter

Pin

Figure 3-5

2.Remove the two screws from the tail bracket as shown in Fig. 3–6.

Handle

Brace

Bell Washer

Hand Knob

Figure 3-4

8.Locate the carriage bolt, bell washer and hand knob packed with your tiller.

Tail Bracket

Screws

Figure 3-6

3.Insert the depth gage bracket into the frame and reinstall the two screws removed earlier. Tighten the hex bolts securely. See Fig. 3–6.

Section 2 — Assembly & Set-Up