3.Periodically check to make sure the blades come to
complete stop within approximately (5) five seconds after
operating the blade disengagement control. If the blades do not stop within the this time frame, your machine should be serviced professionally by an authorized MTD Service Dealer.
4.Check brake operation frequently as it is subjected to wear during normal operation. Adjust and service as required.
5.Check the blade(s) and engine mounting bolts at frequent intervals for proper tightness. Also, visually inspect blade(s) for damage (e.g., excessive wear, bent, cracked). Replace the blade(s) with the original equipment manufacturer's (O.E.M.) blade(s) only, listed in this manual. "Use of parts which do not meet the original equipment specifications may lead to improper performance and compromise safety!"
6.Mower blades are sharp. Wrap the blade or wear gloves, and use extra caution when servicing them.
7.Keep all nuts, bolts, and screws tight to be sure the equipment is in safe working condition.
8.Never tamper with the safety interlock system or other safety devices. Check their proper operation regularly.
9.After striking a foreign object, stop the engine, disconnect the spark plug wire(s) and ground against the engine. Thoroughly inspect the machine for any damage. Repair the damage before starting and operating.
10.Never attempt to make adjustments or repairs to the machine while the engine is running.
11.Grass catcher components and the discharge cover are subject to wear and damage which could expose moving parts or allow objects to be thrown. For safety protection, frequently check components and replace immediately
with original equipment manufacturer's (O.E.M.) parts only, listed in this manual. "Use of parts which do not meet the original equipment specifications may lead to improper performance and compromise safety!"
12.Do not change the engine governor settings or
13.Maintain or replace safety and instruction labels, as necessary.
14.Observe proper disposal laws and regulations for gas, oil, etc. to protect the environment.
15.According to the Consumer Products Safety Commission (CPSC) and the U.S. Environmental Protection Agency (EPA), this product has an Average Useful Life of seven (7) years,
or 390 hours of operation. At the end of the Average Useful Life have the machine inspected annually by an authorized service dealer to ensure that all mechanical and safety systems are working properly and not worn excessively. Failure to do so can result in accidents, injuries or death.
Donot modify engine
To avoid serious injury or death, do not modify engine in any way. Tampering with the governor setting can lead to a runaway engine and cause it to operate at unsafe speeds. Never tamper with factory setting of engine governor.
Notice RegardingEmissions
Engines which are certified to comply with California and federal EPA emission regulations for SORE (Small Off Road Equipment) are certified to operate on regular unleaded gasoline, and
may include the following emission control systems: Engine Modification (EM), Oxidizing Catalyst (OC), Secondary Air Injection (SAI) and Three Way Catalyst (TWC) if so equipped.
SparkArrestor
| internal combustion | engine | and should | not | be used |
_ | ARNING! This | machine | is equipped | with | an |
| on or near any unimproved |
| |||
| brushcovered or | ||||
engine's exhaust system is equipped with a spark arrester meeting applicable local or state laws (if any).
Ifa spark arrester is used, it should be maintained in effective working order by the operator. In the State of California the above is required by law (Section 4442 of the California Public Resources Code). Other states may have similar laws. Federal laws apply on federal lands.
A spark attester for the muffler is available through your nearest engine authorized service dealer or contact the service department, RO. Box 361131 Cleveland, Ohio
WARNING! Your
SAVETHESEiNSTRUCTiONS!
6 I SECTION 2
