Shoulder Screw |
Lock Nut |
Shoulder Screw |
Lock Nut |
Figure 5
•If the gauge wheels have excessive clearance with
the surface below, lower the wheels to the index hole that provides the approximate 1/2" clearance as described above.
Refer to Leveling the Deck on page 16 of this manual for more detailed instructions regarding various deck adjustments.
Starting the Engine
WARNING: Do not operate the tractor if the interlock system is malfunctioning. This system was designed for your safety and protection.
NOTE: Refer to the TRACTOR
•Insert the tractor key into the ignition switch.
•Place the PTO/Blade Engage knob in the disengaged (OFF) position.
•Engage the tractor’s parking brake.
•Place the throttle control in the FAST position
•Pull the choke control outward.
•Turn the ignition key clockwise to the START position. After the engine starts, release the key. It will return to the ON position.
IMPORTANT: Do NOT hold the key in the START position for longer than ten seconds at a time. Doing so may cause damage to your engine’s electric starter.
•After the engine starts, deactivate the choke control.
NOTE: Do NOT leave the choke control on while operating the tractor. Doing so will result in a "rich" fuel mixture and cause the engine to run poorly.
Stopping the Engine
WARNING: If you strike a foreign object, stop the engine, disconnect the spark plug wire(s) and ground against the engine. Thoroughly inspect the machine for any damage. Repair the damage before restarting and operating
•If the blades are engaged, place the PTO/Blade Engage knob in the disengaged (OFF) position.
•Place the throttle control near the FAST position
•Turn the ignition key counterclockwise to the STOP position.
•Remove the key from the ignition switch to prevent unintended starting.
Engaging the Parking Brake
To engage the parking brake:
•Fully depress the brake pedal and hold it there while gently pushing the parking brake lever downward.
•Hold the parking brake lever down while removing your foot from the brake pedal.
•Once engaged, the parking brake lever and the brake pedal will lock in the “down” position.
To disengage the parking brake:
•Slightly depress the brake pedal.
NOTE: The parking brake must be engaged if the operator leaves the seat with the engine running or the engine will automatically shut off.
Driving The Tractor
WARNING: Avoid sudden starts, ex- cessive speed and sudden stops.
WARNING: Do not leave the seat of the tractor without first placing the PTO/Blade Engage knob in the disengaged (OFF) position, depressing the brake pedal and engaging the parking brake. If leaving the tractor unattended, also turn the ignition key off and remove the key.
•Briefly depress the brake pedal to release the parking brake. Move the throttle lever into the FAST (rabbit) position.
IMPORTANT: Do NOT attempt to change the direction of travel when the tractor is in motion. Always bring the tractor to a complete stop before pivoting the drive pedal from forward to reverse or vice versa.
13
