Step 8.
a)Locate and align the holes in the upper rear tube (53) with the side tubes (56). Locate and align the holes in the lower rear tube (53) with the bottom tube (52).
b)Stand in the bottom of the hopper. Insert the end of the spring rod (58) into the lower holes aligned in step a. Pull up on the upper rear tube (53) and insert the other end of the spring rod (58) into the upper holes.
Please note that this step must be done with eye protection (safety glasses) and gloves as the spring rod requires some force to install.
After installation the spring rod will be slightly bent.
53
56
58
53
56 | 52 |
| |
| 54 |
“J”Channel
Step 9.
50 
45
53 | 5/16" x | |
Qty. 2 | ||
|
45
|
|
| 47 |
|
|
| 54 |
|
|
| 33 |
|
|
| 51 |
47 |
|
| 9 |
| Snap |
| |
|
| 57 | |
|
| “J”Channel | |
|
|
|
a.) Attach pull rope(50) to the middle of rear tube(53).
b)Attach hamper mount tube (57) with hex bolts, washers, and lock nuts as shown. Do not overtighten. Hamper mount tube must be free to pivot. Attach Vinyl Cap (33) to hamper mount tube (57) as shown.
c)Pull up the bottom of the hamper, and snap the “J” channel of the hamper bottom to the hamper stop rod (54). Secure the snaps as shown. bent.
d)Attach the Lock Nuts (47) to the Hamper Stop Rod (54).
9
5/16" Nylon Lock Nut
Qty. 2
51
5/16" Flat Washer
Qty. 4
47
3/8" Hex Lock Nut
Qty. 2
