•When chopping fresh herbs, garlic, onion, zest, bread crumbs, nuts, etc., make sure the blender jar and cutting assembly are completely dry.
•If food tends to stick to the sides of the blender jar or food processor work bowl during use, pulse in short bursts.
DON’T:
•Don’t store food or liquids in your blender jar.
•When using blender, don’t place cutting assembly and locking ring onto motor base without the blender jar attached.
•Blender or food processor will not mash potatoes, knead dough, or beat egg whites.
•Don’t remove blender jar or food processor bowl while unit is ON. Keep the blender jar or food processor cover on while blending.
•Don’t twist locking ring from blender jar when removing blender jar from motor base. Simply lift blender jar from motor base.
•Don’t overprocess foods. Blender or food processor will achieve most desired results in seconds, not minutes.
•Don’t overload blender or food processor. If the motor stalls, turn OFF immediately, unplug the unit, and remove a portion of the food; then continue.
•Don’t use any utensil inside the blender jar or food processor bowl while the motor is ON.
•Don’t use any container or accessories not recommended by Cuisinart. Doing so may result in injury.
•Don’t place hands inside the blender jar or food processor bowl when blender is plugged in.
•Don’t add boiling liquids or frozen foods (except ice cubes or ½" pieces of frozen fruit) to glass blender jar. Boiling liquids should cool for 5 minutes before being placed in blender jar.
•The food processor accessory is not intended to crush ice. This could damage the chopping blade and will damage work bowl.
FOOD PROCESSOR PARTS
AND FEATURES
1. Food pusher with oil dispenser
2.Work bowl cover with feed tube
3.Stainless steel chopping blade
4. Stainless steel reversible slicing/ shredding disc
5. Adapter stem
6. Clear work bowl
7. Gearbox collar
8. Motor base
Used for both the blender jar and the food processor bowl
FOOD PROCESSOR
ASSEMBLY
Please note that the bowl and collar will fit on the base in eight different positions. The handle can be in front or on either side and the feed tube in front, back, or on either side. Directions for use reference a certain position for instructional purposes only.
1.Hold gearbox collar in one hand and work bowl handle in the other. Twist bowl
clockwise onto collar.
2. Place collar with bowl onto motor base with handle facing front.
Now follow directions below for either:
a)chopping, puréeing and mixing or
b)slicing and shredding
a)CHOPPING, PURÉEING & MIXING
1.Place chopping blade over shaft in work bowl. Chopping blade should slide easily to the bottom of the bowl. Lower blade will almost touch bottom of bowl.
1
2
3
4
5
6
7
8
8
