Cumberland Stove Works OMMF3500 Unpacking and Assembly, Mount Legs, Mount Handle to Hopper Door

INSTALLATION AND OPERATION MANUAL

MF3500G, MF3500S, MF3500B Models

UNPACKING AND ASSEMBLY

The MF3500 parlor stove is bolted to a skid to prevent movement during shipping. To free the stove from the skid you must remove the two hold-down bolts in the base of the unit.

Unpack all hardware located in the units hopper. The following should be included:

(4) legs w/ leveler	hopper lid handle
(12) leg bolts	power cord
(4) tie-down straps	round vent transition
(4) tie-down bolts	gasket for round vent
ash shuttle rod	(4) 1/4-20 x 1/2” bolts
spring for ash shuttle rod	(2) hopper lid handle
	bolts
MOUNT LEGS	Leg Assembly

1.Gently tilt the stove on the side opposite of the controller.

2.Assemble the legs using provided (12) leg bolts as

shown.

NOTE: If unit is to be used in a mobile home, you must install the (4) tie-down straps to the stove now. Refer to page 13 for instructions.

3. After all bolts have been tightened properly, set the stove	Hopper Door Handle Assembly
back up on its legs.

MOUNT HANDLE TO HOPPER DOOR

1. Using a Phillips screwdriver, attach hopper handle to hopper door using pre-drilled holes.

ASSEMBLE ASH SHUTTLE ROD

1.Thread spring over non-threaded end of rod.

2.Place threaded end of ash shuttle rod through decorative casting and screw into fire pot.

Ash Shuttle Rod Assembly

800-345-6007 CumberlandStoveWorks.com Page