INSTALLATION AND OPERATION MANUAL
MF3500G, MF3500S, MF3500B Models
Startup SEQUENCE OF EVENTS
After the stove is plugged in the wall receptacle, the controller prompts the operator for commands. The parlor stove will start, stop and continue operation at the preset temperature.
COMPONENT | OPERATION START | OPERATION END |
|
|
|
Exhaust Blower | Starts Immediately. | Will continue until shutdown. Shutdown will |
|
| occur when the operating temperature is |
|
| below 90º. |
|
|
|
Feed Auger | Auger automatically starts when ON key is | The auger will continue at the feed rate |
| pushed. | specified by the HEAT SETTING. |
|
| NOTE: Safety switches must be activated to |
|
| continue proper operation. |
|
|
|
Room Fan | Room fan starts when stove heats up to 110ºF. | Will continue to operate until the stove cools |
|
| down to below 90ºF. This may take several |
|
| minutes after fire is out. |
|
|
|
Automatic Shutdown | If after 15 minutes, the stove has not reached | Should the timer expire before the preset |
| the preset operating temperature, the unit will | operating temperature is achieved, wait 30 |
| begin to automatically shutdown. | seconds, then simply reset the stove by |
|
| pressing the OFF key. |
|
|
|
Normal Operation | If after 15 minutes the preset operating | Operation will continue until either the stoves |
| temperature of 110°F is achieved, normal | control is to the OFF position, or the operating |
| operation will continue. | temperature falls below 90ºF. At such time the |
|
| stove will default to the Automatic Shutdown. |
|
|
|
SHUTDOWN SEQUENCE OF EVENTS
Once the parlor stove has reached the normal operating temperature and switched to OFF the unit will immediately stop feeding fuel and continue safety shutting down for at least 30 minutes.
COMPONENT | shutdown | OPERATION END |
|
|
|
Exhaust Blower | Unchanged operation until preset OFF | Continues until the operating temperature falls |
| temperature is achieved. | below 90º. May take several minutes, up to an |
|
| hour. |
|
|
|
Feed Auger | Auger stops feeding fuel. | NOTE: Safety switches must be activated to |
|
| continue proper operation. |
|
|
|
Room Fan | Unchanged operation until preset OFF | Will continue to operate until the heater cools |
| temperature is achieved. | down to below 90ºF. This may take several |
|
| minutes. |
|
|
|
Over Temperature Shutdown | If the heater’s HIGH LIMIT sensor detects | It is rare that the HIGH LIMIT temperature is |
| HIGH HEAT, an automatic shutdown is | reached. However, should this error occur, |
| activated. | let the heater cool down for an hour before |
|
| attempting to restart. |
|
|
|
CumberlandStoveWorks.com | Page 19 |
