Cumberland Stove Works OMMF3500 Operating Instructions, Understanding the TRI-X Controller

INSTALLATION AND OPERATION MANUAL

MF3500G, MF3500S, MF3500B Models

OPERATING INSTRUCTIONS

UNDERSTANDING THE TRI-X CONTROLLER

The controller is located on the lower right-hand side of the parlor stove. It uses an advanced microprocessor that allows the owner to burn multiple fuels with the touch of a key. The TRI-X screen will display, for the user, a sequence of stove functions and any faults that may occur during operation. Each key functions with a small light (LED) that indicates stove heat transitions and running status.

ON KEY

Pressing the ON key will begin the startup sequence for the stove. Fuel will feed through the auger feed system after a brief exhaust check. This check assures the burn area is sealed and the flue gases are exiting the building. The draft fan (exhaust) will start as soon as the ON key is pressed. The fan will automatically adjust speed to match the heat requirement. The circulating blower will turn on when the stove heat level has reached 110°F. When this temperature is reached, the dial to the right of the TRI-X controller is used to adjust room blower fan speed. The TRI-X screen shows the stove progress and will come to rest on [STOVE CONTROLLED BYTEMP KEY {heat level 1 thru 6}] when the stove is heating normally.

The LED light will illuminate when the ON key is pushed and remains on during normal operation.

OFF KEY

Pressing the OFF key will cause the stove to begin the shut-down sequence. If the OFF key is pushed during normal operation, wait 30 seconds before attempting any re-light of the fire. Once the fire goes out and the stove cools down, the blowers will stop running. During a fault condition, follow the instructions on the TRI-X screen and push the OFF key until the [SELECT FUEL TYPE USE MODE KEY] screen appears.

The LED will illuminate when the OFF key is pushed and remains on when the stove is not providing heat.

MODE KEY

The type of fuel is selected by pressing the MODE key. All the currently approved fuels can be viewed when scrolling (pressing) the MODE key.

There is no LED with this key.

TEMP UP OR TEMP DOWN KEYS

Pressing the TEMP UP or the TEMP DOWN keys will adjust the amount of fuel and air being delivered to the fire pot. There are six levels of heat from which to choose. Each level has been calibrated to deliver the correct ratio of air and fuel into the fire pot for the selected fuel type.

Controller Faceplate

L H 720038

Circulating Blower Dial Faceplate

Page 16 CumberlandStoveWorks.com 800-345-6007