Remote Control
The remote control requires 2 x AAA Lithium Battery (not included).
Battery Installation
1.Open the battery compartment cover.
2.Insert two “AAA” batteries (not included) to match the polarities as indicated inside the battery compartment.
3.Close the cover.
Setting the Clock
The clock can be set by using the MEMO buttons on the remote control.When it is on standby Mode.
Setting the Clock
1.Connect the main plug to a main supply scoket.
2.Press and hold the MEMORY button on the remote control, until the digit is Flashing.
3.Press TONE button, the display will show the time with the hours flashing, use either of the SKIP buttons to select the hours and press MEMO button, the hours stops flashing and set.
4.The display will show the time with the minutes flashing, Use either of the SKIP buttons to select the minutes and press MEMO button, the minutes stops flashing and set.
The clock is now set.
Note: When the batteries become too weak ,the operating distance of the remote controller is greatly reduced and you will need to replace the batteries.
Operating the remote control
Point the remote control at the front of the CD micro system, to operate. The IR sensor is located below the LCD display.
The remote control will work up to 7m away from the IR sensor.
Do not block the path of the beam from the remote control to the unit. Dark walls, direct sunlight or very bright light will reduce the sensitivity of the IR sensor.
Colour
You can change the colour on the display by pressing the COLOUR button (Blue/ Green/ Cyan/ Red/ Yellow/ Purple/ White). You may change to another colour by pressing the COLOUR button again.
5
