Cypress CY3270 manual Ftmf Expansion Card Demonstrations

Getting Started

3.From the top menu bar, click Build and then select Generate/Build {your project name} Project. Click Next in the following two screens.

4.From the top menu bar, click Program and then select Programmer. Within the Programmer window, select Port > FirstTouch and set the Programming Mode button to Reset. Select the File Load button. Within the ‘Open’ window, double-click {your project name}.hex located in

{your project folder}\{your project name}\output under the default \..\My Documents folder or the alternate folder you designated. Then, click the Program button.

5.Once programming completes successfully, verify the project operation by doing as follows:

a.Temperature Sensing–the LED color varies based on changes in the ambient temperature (the buzzer sounds at extreme temperatures).

b.Light Sensing–the LED intensity varies based on changes in the ambient light.

c.CapSense Proximity Sensing–the LED color varies based on your hand’s proximity to the board.

2.4FTMF Expansion Card Demonstrations

The FTMF Expansion Card provided in your kit is capable of supporting a variety of demonstrations. Each demonstration has an associated PSoC Express project and data sheet that describes the operation and usage of each of the demonstrations in detail. Since the FTMF expansion card has its own PSoC, you can remove it from the FTPC bridge and insert it into your target hardware or other development platform. In order to observe each of the various FTMF demonstrations, it is necessary to reprogram the FTMF card with the appropriate demonstration firmware. For more details refer to the Technical Reference chapter on page 17.

Figure 2-1. FTMF Expansion Card

Proximity

Antenna

Buzzer

Temperature

Sensor

CapSense

Slider

Light Sensor

LED Display

8 CY3270 PSoC® FirstTouch™ Guide, Document # 001-15945 Rev. **