Manuals / Vivotek / Household Appliance / Home Security System

Vivotek FD7130 Network Deployment, Power over Ethernet PoE When using a PoE-enabled switch

Models: FD7130

1 14

Download 14 pages 60.12 Kb

Page 10

Image 10

English

5Network Deployment

Power over Ethernet (PoE)

When using a PoE-enabled switch

This Network Camera is PoE-compliant, allowing transmission of power and data via a single Ethernet cable. Follow the below illustration to connect the camera to a PoE-enabled switch via Ethernet cable.

PoE Switch

When using a non-PoE switch

Use a PoE power injector (optional) to connect between the Network Camera and a non-PoE switch.

PoE Power Injector

(optional)

Non-PoE Switch

EN - 9

Page 10

Image 10

Vivotek FD7130 Network Deployment, Power over Ethernet PoE When using a PoE-enabled switch, When using a non-PoE switch

Contents

Vandal-proof . Tamper Detection . PoE Quick Installation GuideFD7130 IP SurveillanceWarning Before Installation Keep the Network Camera away from direct sunlightDo not drop the Network Camera Do not place the Network Camera on unsteady surfacesDo not disassemble the Network Camera Do not insert sharp or tiny objects into the Network CameraWarranty Card 1 Package ContentsQuick Installation Guide Liquid Tight Connectors forOuter View 2 Physical DescriptionInner View Waterproof Level IP66RJ45 Cable Dimension unit mm 3 Cabling AssemblyRJ45 Cable Connector ConnectorAssembling Steps M12 Cable ConnectorM12 Cable Dimension unit mm Components of the Waterproof Connector Ø4.5mm~Ø6.5mm4 Hardware Installation Ceiling MountPlease secure the screws tightly to Installing the Ground WireWall Mount avoid moistureWhen using a non-PoE switch Power over Ethernet PoE When using a PoE-enabled switch5 Network Deployment 6 Assigning an IP Address Network CameraTo adjust the viewing angle 8 Adjusting the Lens7 Ready to Use 9 Completion Fine-tune the Camera Focus