D-Link DCS-3410 Add a Camera

47D-Link DCS-3410 User Manual

Section 4 - D-ViewCam Installation

Add a Camera

To start D-ViewCam, select Start > All Programs > D-Link > D-Link

D-ViewCam.

Enter Admin as the default user name and leave the password blank.

Click / OK to log into the system and access the Add Camera

Wizard.

Note: Please refer to page 51 in the D-ViewCam user manual

to change your password.

This section will show you how to start and add a camera to the D-ViewCam system.

Contents

Main Table of Contents System Requirements Product Overview Package Contents Introduction Features Page Hardware Overview Hardware Installation Page Page Page Page Page Page Page Page Page Web-based Conguration Utility Live Video Camera Setup Wizard Internet Connection Setup Wizard Page Page Page Motion Detection Setup Wizard Page Page Network Setup Page Dynamic DNS Image Setup Audio and Video Motion Detection Time and Date Recording In this section, you can congure and schedule the recording setting for your IP camera. Snapshot Digital Output You may enable the Digital Output (DO) feature and congure the source of event for your camera. RS-485 Maintenance Device Management Backup and Restore In this section, you may backup, restore and reset the settings as well as reboot your camera. Firmware Upgrade Page Page Page D-ViewCam Installation Page Page Add a Camera Page Page Page Page Troubleshooting Page Page Networking Basics Check your IP address Statically Assign an IP address Technical Specications Networking Video Audio Microphone OS Support Physical Environment Emission (EMI), Safety & Other Certications Contacting Technical Support Warranty Limited Warranty: Limited Software Warranty: Non-Applicability of Warranty: What Is Not Covered: Disclaimer of Other Warranties: Page FCC Statement: IMPORTANT NOTICE: