Web-based Management, Login | D-Link DES-1252 specification

Web-based Management

The DES-1252 Web-Smart Switch has a web browser GUI interface for configuring the Switch through a web browser. To see the list of web browsers the Web-based Utility supports, see Supported web browsers on page 19. A network administrator can manage, control and monitor the switch from the local LAN. This section indicates how to configure the Switch to enable its smart functions.

Login

In order to login and configure the switch via an Ethernet connection, the PC must have an IP address in the same range as the switch. For example, if the switch has an IP address of 192.168.0.1, the PC should have an IP address of 192.168.0.x (where x is a number between 2 and 254), and a subnet mask of 255.255.255.0. Open your web browser and enter http://192.168.0.1 (the factory-default IP address) in the address box. Then press <Enter> (Figure 14)

Figure 14 – Logging into the Switch’s (DHCP assigned) IP address

The web configuration can also be accessed through the SmartConsole Utility. Open the SmartConsole Utility and double-click the switch as it appears in the Monitor List. This will automatically load the web configuration in your web browser.

When the following logon box appears, enter "admin" for the password. Press Ok to enter the main configuration window. (Figure 15)

27

Image 32

D-Link DES-1252 user manual Web-based Management, Login

Contents

DES-1252 Table of Contents Page Iii Page Purpose Terms/Usage Gigabit Ethernet Technology Introduction Switching Technology Fast Ethernet Technology Features IEEE802.1X Port-based Access Control Technical Specifications Key Components / Performance Switching CapacityForwarding Mode Max. Forwarding Rate Sdram for CPU Flash MemoryPort Functions Combo ports Chassis Dimensions Reset button onTemperature 1000Mbps Copper Storage Temperature Power consumptionEmission EMI and Safety Certifications Humidity Installation Unpacking Rack Mounting Attach the adhesive rubber pads to the bottom Connecting Network Cable Attach the mounting brackets to the Switch AC Power Reset button LED IndicatorFront Panel 10/100 BASE-TX Twisted Pair Ports Port 1~48 10/100/1000 BASE-T Twisted Pair Ports Port 51~52 AC Power ConnectorRear Panel Power LEDs Understanding LED IndicatorsPower and System LEDs Ports 1 ~ 48 Status LEDs Link/Act 10/100Mbps shown in Amber Light Link/Act for UTP portsPorts 51~52 10/100/1000 Base-T LEDs Link/Act Page Installing the SmartConsole Utility Supported web browsers SmartConsole Utility Features Menu Toolbar Option includes Refresh Time and Group Interval functions Definitions of the Discovery List features Discovery List Monitor List Definitions of the Monitor List functions and terms View trap Device Setting This space has been intentionally reserved for notes Firmware Upgrade Login Web-based Management Log in screen Tool Menu Tool Menu Setup Menu Tool Menu Firmware Backup and Upload System System Setting C P System Trap Setting System System Setting System Port Setting System Trap Setting System Port Setting System Snmp Setting System Snmp Setting System Password Access Control Configuration 802.1Q Vlan Configuration 802.1Q Vlan Default Setting Configuration 802.1Q Vlan Add VID Configuration Trunking Configuration 802.1Q Vlan VID Assignments Configuration Igmp Snooping Configuration Igmp Snooping ConfigurationPage Page Configuration 802.1D Spanning Tree Configuration Igmp Router port Settings Configuration Spanning Tree Page Configuration Port Mirroring Configuration Port Mirroring QoS 802.1p Default Priority Security Safeguard Engine Security 802.1X Setting Security Broadcast Storm Control Security 802.1X Setting Page Security Mac Address Table Static Mac Security Static Mac Address Security Mac Address Table Dynamic Forwarding Table Monitoring Statistics Monitoring Statistics Monitoring Port Statistics