D-Link DES-818, DES-810 manual Connecting Power, Network Connections, 10/100Mbps Ports

10/100 Fast Ethernet Switch User’s Guide

Connecting Power

Power is supplied to the 10/100 Fast Ethernet Switch through an AC power cord. The AC power input voltage ranges from 100 to 240 VAC. A power cable is included with the device.

Figure 5 Connecting Power

Network Connections

If any port on the 10/100 Fast Ethernet Switch is set for full-duplex operation, the device (or LAN) connected to that port should also be set for full-duplex operation. The following sections discuss the requirements for each operating mode.

10/100Mbps Ports

These ports (1 and 2 on both models) require Category 5 unshielded twisted- pair or shielded twisted-pair (UTP/STP) cable to run at 100Mbps. The attached station must be within 100 meters of the 10/100 Fast Ethernet

Installation 15