D-Link DGE-500SX manual Parameters supported by the DLKGE.LAN driver

LOAD C:\NWSERVER\NBI.NLM

LOAD C:\NWSERVER\MSM.NLM

LOAD C:\NWSERVER\ETHERTSM.NLM

LOAD C:\NWSERVER\DLKGE SLOT=1 FRAME=Ethernet_802.3

NAME=DLKGE_1_E83

BIND IPX DLKGE_1_E83 NET=xxxx

LOAD C:\NWSERVER\DLKGE SLOT=1 FRAME=Ethernet_802.2

NAME=DLKGE_1_E82

BIND IPX DLKGE_1_E82 NET=xxxx

LOAD C:\NWSERVER\DLKGE SLOT=1 FRAME=Ethernet_II

NAME=DLKGE_1_EII

BIND IPX DLKGE_1_EII NET=xxxx

LOAD C:\NWSERVER\DLKGE SLOT=1 FRAME=Ethernet_SNAP

NAME=DLKGE_1_ESP

BIND IPX DLKGE_1_ESP NET=xxxx

6. Restart the server again.

Parameters supported by the DLKGE.LAN driver

SLOT 1 – Forces the driver to search for the specified card.

FULLDUPLEX – The FULL-DUPLEX parameter causes the DLKGE to operate in full-duplex mode. When operating in full-duplex mode, the DLKGE can simultaneously transmit and receive packets.

AUTONEGOTIATE – The AUTO-NEGOTIATE parameter causes the DLKGE to auto negotiate the duplex mode and link speed with the device being connected.

TXDMATHRESHOLD – The TXDMATHERESHOLD determines the I/O method used to move transmit packets from host memory to the DLKGE memory. The valid range for the TXDMATHRESHOLD is 0 - 1514. the default value is 800.

DISABLERXIP – Disables the DLKGE TCP/IP Receive Packet checksum support. By default, the DLKGE will perform TCP/IP checksum verification on received packets in hardware if the operating system supports this capability.

Due to the large number of Network Operating Systems (NOSs) supported, detailed driver‡ software installation instructions are given in README.TXT files on the DGE-500SX Software Diskette/CD-ROM. Review the root directory README for overview information. For detailed installation instructions see the README and referenced instruction files in the subdirectory corresponding to your network operating system.

‡Check http://www.dlink.com periodically for driver upgrades.

10