Networking Basics, Check your IP address | D-Link DGS-1005G specs

Networking Basics

Check your IP address

After you install your new D-Link adapter or if you already have an Ethernet adapter installed on your computer, by default, the TCP/IP settings should be set to obtain an IP address from a DHCP server (i.e. router) automatically. To verify your IP address, please follow the steps below.

•Click on Start > Run. In the run box type cmd and click OK. (Windows® 7 and Vista® users type cmd in the Start Search box.)

•At the prompt, type ipconfig and press Enter.

•This will display the IP address, subnet mask, and the default gateway of your adapter.

ENGLISH

18

Image 18

D-Link DGS-1005G manual Networking Basics, Check your IP address

Contents

Page Preface Revision Date Table of Contents Safety Instructions Safety Cautions English Protecting Against Electrostatic Discharge Setup Introduction Fast Ethernet Technology Gigabit Ethernet Technology Switching Technology 802.1p Priority TaggingJumbo Frame Support Features Hardware Overview Top Panel LEDs Link/Act/Speed Power IndicatorCable Diagnostics − LED Indications Open, Short, or Improper Termination Power Jack Rear Panel ConnectionsAuto MDI/MDI-X Ports Installation Before You Connect to the Network Mounting the Switch on the Wall Mounting on a cement wallMounting on a wood wall Connecting To Network Backbone or Server Connecting the SwitchHub/Switch to DGS-1005G DGS-1005G to End Node Troubleshooting Does the DGS-1005G switch have an uplink port? Networking Basics Check your IP address Statically Assign an IP address Step Glossary Bootp CSMA/CD IPX LANMDI Rmon MDI-XMIB RPS UDP TCP/IPTftp Vlan Technical Specifications EMI RJ-45 Pin Specifications Packet Filtering / Forwarding RateMAC Address Learning Contacting Technical Support Phone SupportInternet Support Registration