Rear Panel Connections, Auto MDI/MDI-X Ports | D-Link DGS-1005G

Rear Panel (Connections)

ENGLISH

Auto MDI/MDI-X Ports:

Five (5) Gigabit Ethernet, Auto-Negotiating ports (10/100/1000Mbps) Comprehensive LED indicators display the conditions of the Switch and status of the network.

Power Jack:

Power is supplied through an external power adapter. Check the technical specification section for information about the power input voltage. Since the DGS-1005G does not require a power button, plugging its power adapter into a power outlet will immediately power it on.

13

Image 13

D-Link DGS-1005G manual Rear Panel Connections, Auto MDI/MDI-X Ports, Power Jack

Contents

Page Revision Date Preface Table of Contents Safety Cautions Safety Instructions English Protecting Against Electrostatic Discharge Introduction Setup Gigabit Ethernet Technology Fast Ethernet Technology 802.1p Priority Tagging Switching TechnologyJumbo Frame Support Features Top Panel LEDs Hardware Overview Cable Diagnostics − LED Indications Power IndicatorLink/Act/Speed Open, Short, or Improper Termination Rear Panel Connections Power JackAuto MDI/MDI-X Ports Before You Connect to the Network Installation Mounting on a cement wall Mounting the Switch on the WallMounting on a wood wall Hub/Switch to DGS-1005G Connecting the SwitchConnecting To Network Backbone or Server DGS-1005G to End Node Does the DGS-1005G switch have an uplink port? Troubleshooting Check your IP address Networking Basics Step Statically Assign an IP address Glossary CSMA/CD Bootp LAN IPXMDI MIB MDI-XRmon RPS Tftp TCP/IPUDP Vlan EMI Technical Specifications Packet Filtering / Forwarding Rate RJ-45 Pin SpecificationsMAC Address Learning Phone Support Contacting Technical SupportInternet Support Registration