![](/images/new-backgrounds/1306420/30642065x1.webp)
Section 3 - Configuration
This will allow you to open a single port. If you would like to open a range of ports, refer to page 33.
Name: Enter a name for the rule or select an application from the
IP Address: Enter the IP address of the computer on your local network that you want to allow the incoming service to. If your computer is receiving an IP address automatically from the router (DHCP), you computer will be listed in the “Computer Name”
Private Port/ Enter the port that you want to open next to Private Public Port: Port and Public Port. The private and public ports are usually the same. The public port is the port seen from the Internet side, and the private port is the port being used by the application on the
computer within your local network.
Protocol Type: Select TCP, UDP, or ANY from the
Inbound Filter: Select Allow All (most common) or a created Inbound filter. You may create your own inbound filters in the Advanced > Inbound Filter page.
Schedule: The schedule of time when the Virtual Server Rule will be enabled. The schedule may be set to Always, which will allow the particular service to always be enabled.You can create your own times in the Tools > Schedules section.
33 |