D-Link DWA-140 manual Configure Connection 1 for Dhcp for WAN

Models: DWA-140

1 88
Download 88 pages 58.12 Kb
Page 40
Image 40

Configure Connection 1 for DHCP for WAN

Dynamic Host Configuration Protocol (DHCP) allows the gateway to automatically obtain the IP address from a DHCP server on the service provider’s network. The service provider assigns a global IP address from a pool of addresses available to the service provider. Typically the IP address assigned has a long lease time, so it will likely be the same address each time the Router requests an IP address.

Figure 3-13. Setup – Configure Connection 1 for DHCP service for the WAN

To configure the WAN connection for DHCP, perform the steps listed below. Some of the settings do not need to be changed the first time the device is set up, but can be changed later if you choose.

1.Click the Connection 1 button under WAN Setup to view the default PPPoA Connection Setup configuration menu.

2.Select DHCP from the Type: pull-down menu. This action will change the menu so it offers different settings for configuration.

3.Type in a Name: in the space provided (WAN_PPPoA is used in the above example).

4.If you are told to change the VPI or VCI values, type in the values given to you by your service provider. Many users will be able to use the default settings.

5.Leave the default QoS values if you are unsure or the ISP did not provide this information.

6.Do not change the PCR or SCR values unless you are required to do so. If you are told to change these, type in the values given to you by your service provider.

7.The Encapsulation values LLC (SNAP) and VC (MUX) are two different methods of encapsulating the PPP packet. Contact your ISP to make sure which encapsulation is being supported.

8.Click the Apply button when you have entered all the information. The web browser will briefly go blank. You are now finished changing setting for the primary WAN connection known as Connection 1. It is now necessary to save the changes you just made and restart the Router.

9.To save the changes made to Connection 1, click the Tools tab and then click on the System Commands button. Click on the Save All button to store the configuration settings. Click on Back button to return to the System Commands menu.

32

Page 40
Image 40
D-Link DWA-140 manual Configure Connection 1 for Dhcp for WAN