Installation

Installation

General Information

Accessories are available from Graco. Make certain all accessories are adequately sized and pressure-rated to meet your system needs.

Figures 2 thru 4 are only a guide for identifying system components and for assisting in installation. Contact your Graco distributor or Graco Ohio Customer Service for assistance in designing a system to suit your particular needs.

Unpacking

1.Inspect the shipping container carefully for damage. Contact the carrier promptly if there is damage.

2.Open the box and inspect the contents carefully. There should not be any loose or damaged parts in the container.

3.Compare the packing slip against all the items in the box. Report any shortage or other inspection problems immediately.

4.Remove the PR70 system components from the container. Do not lift the machine by the tanks.

Locate and Install the PR70

1.Locate a bench top or equivalent location to mechanically mount the PR70 dispensing machine.

Verify the location has access to compressed air, AC power and is well ventilated.

2.Place the PR70 onto the designated location. Allow to the machine to rest on the rubber feet provided.

3.Turn the Shield Locking Screws clockwise on both sides to remove the PR70 protective shield.

4.Attach the PR70 frame to the selected location by installing fasteners (not provided with unit) thru the 4 mounting holes. Refer to Figure 1 for mounting hole dimensions.

Machine Setup

Avoid contact with electrical inter-connects, when connecting electric power to the machine. Read all manufacturer’s warning and material MSDS to know the specific hazards of the material used.

1.Connect a compressed airline to the input air in the back of the machine.

2.Load material into the on-board or off-board tanks feeding the machine.

3.Using the power cord provided, connect AC power (100-240V, 50/60 Hz, single-phase) to the machine.

Figure 1: Mounting Hole Dimensions for Installing the PR70 Machine (dimensions in inches/mm)

312393G

7 of 50

Page 7
Image 7
Graco Installation, General Information, Unpacking, Locate and Install the PR70, Machine Setup