Disable Mode, Entering Set-up Screens

Machine Disable Mode (“”red)

Figure 6: Typical Run Screen when Machine in “Disable” Mode

1.At any time and from any screen, to immediately disable all machine motion, press (red).

2.If activated, the purge timer will be disabled

3.To resume operation, the machine must be put back into an operating mode as described in the Machine Mode Selection section.

4.If activated, the purge timer will not restart until a shot is taken.

Setup Screens

Before the machine will operate properly, it must be calibrated and shot size information must be entered.

Entering the Setup Screens

1.From the Run screen press . If no password has been programmed into the HMI, the Programming Mode Selection Screen (Figure 7) will be displayed.

Figure 7: Programming Mode Selection Screen

2.To enter the calibration screens, press . To enter the maintenance screens, press . Refer to Figure 9 for a screen navigation diagram.

Setup Screens with Passwords Enabled

1.From the Run screen press . If a password has been programmed, the Password Entry Screen (Figure 8) will be displayed.

Figure 8: Password Entry Screen

2.Enter the 6 digit password by pressing the corresponding soft keys, G-J in Figure 5.

3.After the 6th digit has been entered, press .

4.If the correct password has been entered, the Programming Mode Selection Screen will be displayed. Refer to Figure 9 for a screen navigation diagram.

5.If the incorrect password has been entered, the password entry will need to be repeated until the correct 6-digit sequence is entered.

6.To abort the password entry, press .

312393G

11 of 50

Page 11
Image 11
Graco PR70 Machine Disable Mode red, Entering the Setup Screens, Setup Screens with Passwords Enabled