Installation Instructions
Installing the Burner Components
wARNING
•Never attempt to operate the cooktop with any of the burner parts removed.
•Do not attempt to adjust the burner air mixture set- tings. All adjustments are preset at the factory.
1.Remove the burner rings, burner caps and grates from their shipping packages.
2.Assemble the burners as shown. Match the burner parts to the correct size and type of burner. When installing the burner components, make sure they are centered. Twist each piece back and forth slightly until it drops completely into place. The burners will not operate properly unless all of the burner pieces are properly seated. On model DCT305, the left rear burner cap has tabs on the bottom that fit into the slots on the top of the burner ring.
Inner burner cap (bottom shown)
Outer burner cap
Burner ring
Line up
indentations on bottom of burner ring with pins on top of base.
Burner base
SimmerSear™ Burner Assembly(center of cooktop)Burner cap |
| Burner cap | |
(bottom shown) | Fit hole in burner | ||
(bottom shown) | |||
| ring over igniter | ||
| Fit hole in burner | ||
|
| ||
|
| ring over igniter | |
Burner ring |
| Burner ring |
Igniter |
| Igniter | |
|
| ||
CAUTION: Top of |
| CAUTION: Top of | |
igniter is sharp | Burner base | ||
igniter is sharp | |||
|
Burner base
| Standard Burner Assembly | Left Rear Standard Burner Assembly - DCT305 |
8