Installation Instructions
Cooktop Assembly
WARNING
Never attempt to operate the range’s cooktop with any of the burner rings, burner caps or grates removed.
1.Remove the burner rings, burner caps and grates from their shipping cartons.
2.Install the burners as shown. Gently twist each piece back and forth after installation to make sure it is properly seated. A small gap below the bottom of the burner ring is normal.
3.Gently set the grates on top of the spill tray. Put the legs of each grate inside the corresponding dimples.
| Ridge on bottom | Inner burner | |
|
| cap | |
STEP 3: Set inner |
|
| |
dual burner cap on |
|
| |
center of dual burner | Outer burner cap | ||
ring. Line up ridge on | |||
|
| ||
bottom of cap with |
|
| |
pins on center of |
|
| |
burner base. |
|
| |
STEP 2: Set outer |
| Burner ring | |
dual burner cap on |
| ||
dual burner ring. Make |
|
| |
sure it is centered on |
|
| |
top of burner ring. |
|
| |
STEP 1: Install dual burner ring on dual burner base. Line
up indentations on bottom of burner ring with pins on top of burner base.
Pin on burner base
Ridge on bottom of burner cap 
STEP 2: Install all standard burner caps. Ridge on bottom of caps must surround top of ring.
STEP 1: Install standard burner rings on standard burner bases. Put holes on edge of each ring over the igniter. Center tabs on bottom of each ring in hole in center of each base.
Igniter hole
Burner ring - top view
Igniter on burner base
SimmerSear™ Assembly | Standard Burner Assembly |
(left front burner only) | (right front, right rear, left rear) |
15