Dacor EDWH24S Before You Call for Service, Problem Solution Guide, May Be Caused By, What to Do

Before You Call for Service

Problem Solution Guide

Before you call for service, please review the Problem Solution Guide below.

Problem	May Be Caused By	What to Do
Flashing lights on	HEAVY, NORMAL, LIGHT,	Call for service.
control panel	QUICK and RINSE lights
	flashing: Too much water in
	dishwasher
	LIGHT light flashing: Water	Make sure water valve is turned on. Make sure
	inlet problem	water supply line to dishwasher is not kinked.
	QUICK light flashing: Valve	Shut off water supply valve and call for service.
	leakage
	AUTO and HEAVY lights	Check for kinked drain hose. Disconnect end of
	flashing: blocked drain	drain hose. Check for debris in hose or any other
		part of drain system/plumbing. Check to see if filter
		system is clogged (see below).
	AUTO and NORMAL lights	Clean entire filter system. See page 13.
	flashing: clogged filter
	WASH TEMP and DRY cycle	See page 11.
	lights flashing when a button is
	pressed: child safety lock on
Dishwasher will not start	Main power switch is off	Open door and turn on main power switch on top
(control panel is not lit)		of door before selecting cycle. See page 10.
	Power is disconnected	Make sure power is on at the circuit breaker panel
		and that the power plug is properly connected to
		electrical outlet (if applicable).
	Blown fuse or tripped circuit	Replace fuse or reset circuit breaker. Remove
	breaker	other appliances from circuit.
	Power failure	Contact electric company.
Dishwasher will not start	Door not completely closed	Gently push in on front of door until you hear a
(control panel is lit)		click.
	Controls not set	Make sure dishwasher controls are properly set
		and door is closed. See Page 10.
	Child safety lock is engaged	Disengage child safety lock. See page 11.
	(WASH TEMP and DRY cycle
	lights flash when buttons are
	pressed)
	No water supply (delicate light	Make sure water valve is turned on. Make sure
	may flash on control panel)	water supply line to dishwasher is not kinked.
	Drain pump clogged (a loud	Disconnect power plug and clean entire filter
	buzzing sound is heard, lights	system. See page 13. Reconnect power and
	on control panel may flash)	attempt to restart. If problem persists, shut off the
		water valve, disconnect power and call for service.
	Overfilling/leakage	Contact Dacor Customer Service.
	Dishwasher has detected	See Flashing lights on control panel above.
	a fault condition (lights on
	control panel are flashing)

16