Dacor ER30G Cooktop Assembly, Dual Burner Assembly, Standard Burner Assembly, (left front burner only), STEP, STEP, STEP, STEP, STEP, (right front, right rear, left rear)

Installation Instructions

Cooktop Assembly

WARNING

Never attempt to operate the range’s cooktop with any of the burner rings, burner caps or grates removed.

1.Remove the burner rings, burner caps and grates from their shipping cartons.

2.Install the burners as shown. Gently twist each piece back and forth after installation to make sure it is properly seated. A small gap below the bottom of the burner ring is normal.

3.Gently set the grates on top of the spill tray. Put the legs of each grate inside the corresponding dimples.

4.Place each grate onto the top frame, being certain that the rubber feet are positioned in the locating dimples.

	Ridge on bottom	Inner Burner
		Cap
STEP 3: Set inner
dual burner cap on
center of dual burner	Outer Burner Cap
ring. Line up ridge on	Outer Burner Cap
ring. Line up ridge on
bottom of cap with
pins on center of
burner ring.
STEP 2: Set outer		Burner Ring
dual burner cap on		Burner Ring
dual burner ring. Make
sure it is centered on
top of burner ring.

STEP 1: Install dual burner ring on dual burner head. Line

up indentations on bottom of burner ring with pins on top of burner head.

Pin on burner head

Ridge on bottom of burner cap

STEP 2: Install all standard burner caps. Ridge on bottom of caps must surround top of ring.

STEP 1: Install standard burner rings on standard burner bases. Put holes on edge of each ring over the igniter. Center tabs on bottom of each ring in hole in center of each base.

Igniter Hole

Burner Ring -

Top View

Igniter on burner base

Dual Burner Assembly	Standard Burner Assembly
(left front burner only)	(right front, right rear, left rear)