Installation Instructions

Verifying the Package Contents

Parts List

Unpack the range and verify that all required parts have been provided. If any item is missing or damaged, please contact your dealer immediately. Do not install a damaged or incomplete appliance. The customer must report cosmetic issues immediately to the dealer or builder.

WARNING

•Observe all governing codes and ordinances during planning and installation. Contact your local building department for further information.

•If the gas or electric service provided does not meet the product specifications, do not proceed with the installation. Call the selling dealer, the gas supplier or a licensed electrician.

•This appliance must be installed by a licensed plumber or gas fitter when installed within the Commonwealth of Massachusetts.

•Anti-tip bracket

•2 grates

•3 standard burner caps (2 large, 1 small)

•3 standard burner rings (2 large, 1 small)

•1 dual burner ring

•1 outer dual burner cap

•1 inner dual burner cap

•3 oven racks

•Use and care manual

•Ignitor cleaning brush

•Lens pry stick

•Stainless steel cleaner

See the use and care manual for a list of optional parts and accessories.

Backguard Installation

If installing a backguard other than the standard 6-inch version, install it before pushing the range into place. Install it according to the installation instructions accompanying the backguard.

Level and Adjust the Range Height

1.Raise or lower the range until it is the same height as the counter-top. To adjust the height, turn the foot on the bottom of each leg as shown below.

2.Use a level to make sure that the range does not tilt front to back or side to side. Re-adjust the legs as necessary.

up

down

Install the Anti-Tip Bracket

1.Locate the anti-tip foot on the back of the range and turn it until the bottom of it is 1/16” (2 mm) off the floor.

Back of Range

Anti-Tip Foot

6