Installation Instructions

Installing an ERV Raised Vent (Optional)

Install the ERV raised vent before installing the range. See the ERV installation instructions, part no. 103106.

IMPORTANT: The ERV series raised vent attaches to the narrow back portion of the ERV style cutout. It is self-supporting in the cutout and does not actually attach to the range itself.

Installing a Backguard (Optional)

WARNING

Do not operate the range without the island trim or a backguard installed.

NOTES:

Install the backguard before making the range gas and electrical connections.

Dacor recommends that the 24 inch backguard be installed by at least two people.

To install a backguard:

1.Remove the thirteen (13) screws on the front and back of the island trim and slide the trim off the unit.

Trim Removal

2.Remove the backguard from its box.

3.24 inch backguard only: Use eight (8) hex screws from the backguard kit to attach the support brackets to the range chassis. Make sure the gas line is positioned under the bracket as shown below.

Gas Line

4.To avoid scratches, place small scraps of thin cardboard on the rear of the side panels where the backguard will make contact. Place the backguard over the back of the range. Special attention should be given to the lower flange in front of the backguard, which must fit between the stainless steel side panels and over the existing stainless steel trim piece (see range side detail below). On the 24 inch backguard: The “C” channels on the backguard slide into the brackets on the range chassis.

Sliding the Backguard into Place

 

Front Flange

Back of

 

of Backguard

Stainless Steel

 

 

 

 

 

 

 

Backguard

Trim Piece

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Front of

Range

Cooktop

Spill Tray Chassis

Range Back

Cover

Range Side Detail

Hex Screw,

8 Places

Support Bracket Installation for 24 inch Backguard