Design Specifications
Product Dimensions
◊The depth from the front of the door (w/o door handles) to the back of the refrigerator chassis is 27 1/8” (689mm).
◊The depth of the cabinet less door is 24” (610mm).
◊The power cord is 40” (1016mm) long.
◊The height from the top of the refrigerator to floor with the leveling legs in the down position is 70 1/8” (1781mm)
◊The height from the top of the refrigerator to floor with
the leveling legs in the fully extended position is 71 1/4”
(1810mm) at the front of the unit and 70 11/16” (1796mm) at the rear of the unit.
◊The width from the refrigerator from edge to is 35 5/8”
(905mm).
Door Swing Dimensions
The area to the left and the right of the appliance must permit both doors to open to a minimum of 90°. Allow a minimum of 2 1/2” (64mm) space between the side of the refrigerator doors and a corner wall.
Installation Specifications
Tools and Parts
IMPORTANT:
◊Installer: Leave these Installation Instructions with the homeowner.
◊Homeowner: Keep these Installation Instructions for future reference. Save these Installation Instructions for the local electrical inspector’s use.
Tools needed:
Make sure that you have the necessary tools and materials available for a proper installation.
◊Phillips screwdriver set
◊Slotted screwdriver set
◊Torx drive screwdriver set
◊Provide sufficient length 8’ (2.4m) to allow for a minimum of a 24” (610mm) diameter service loop of 1/4” (6mm) copper tubing and saddle valve for the water line (Do not use self- piercing valves)
◊Copper tubing cutter
◊Level - 2’ (.6m) and 4’ (1.2m) recommended
◊Appliance Dolly able to support 700lbs (317kg) and adequate manpower to handle the weight of the appliance
◊Various sized pliers
◊Allen wrench set
◊3/8” hex bolt nut driver or socket set
◊Crescent wrenches
◊Cordless drill and assorted drill bits
◊Masonite, plywood, 1/8” pressed fiberboard, cardboard or other suitable material to protect finished flooring
◊Appropriate materials to cover and protect the home and its furnishings during installation
Location Requirements
Your Dacor® refrigerator can be recessed in an opening between cabinets or installed at the end of a cabinet run using a side panel to enclose the refrigerator.
WARNING
Explosion Hazard – Keep flammable material and vapors, such as gasoline, away from refrigerator.
Failure to do so can result in death, explosion, or fire.
IMPORTANT:
◊Observe all governing codes and ordinances.
◊Do not install the refrigerator near an oven, radiator, or other heat source, nor in a location where the temperature will fall below 55°F (13°C).
◊Floor must support the refrigerator weight, more than 600lbs
(272kg), door panels and contents of the refrigerator.
◊Ceiling height must allow for side tipping radius.
◊Location should permit doors to open fully.