Installation Instructions
To Install:
1.Pull both rails out to full extension.
2.While supporting door front, hook supports into slots located on inside of each slide.
Note
•All four drawer bracket supports must be in the proper slots for the drawer to function properly.
3.Lower door front into final position.
4.Place the basket cradles back onto the drawer slides. Align basket cradle snaps with the slots on the drawer brackets and press each cradle toward the bracket until it clicks.
5. Tilt the lower basket front down and set it down into the basket cradles.
Reinstallation of the Doors
1.Install hinge assemblies:
•Install top hinge loosely with 5/16” hex headscrews.
•Install center hinge with Phillips screws.
•Freezer door models: Install bottom hinge with 3/8” hex head screws.
2.Freezer door models: Insert bottom hinge pin.
•Locate bottom hinge hole closest to outside edge of cabinet, and insert bottom hinge pin. Replace any door shims, if present.
3.Freezer door models: Place hinge side of freezer door on bottom hinge pin and hold freezer door upright while installing center hinge pin with 5/16” hex head driver.
•Replace plastic sleeve.
•Replace any applicable door shims.
• Make sure the hinge pin is installed tightly.
4.Place hinge side of refrigerator door on center hinge pin.
5.While holding refrigerator door upright, tighten down top hinge with 5/16” hex head driver
and replace hinge cover.