Installation Specifications

Rough-In Dimensions

◊A grounded 3 prong non-GFCI electrical outlet should be placed 2” (51mm) from the right side cabinets or end panel.

See “Electrical Requirements” for additional information.

◊The plumbing for the water line can come through the floor flush to or from the back wall. See “Water Supply Requirements” for more information.

36”

701/2” Minimum

24”

Electrical Requirements

WARNING

Electrical shock Hazard – Plug into a grounded 3- prong non-GFCI outlet. Do not remove ground prong. Do not use an adapter. Do not us an extension cord. Failure to do so can result in death, fire, or electrical shock.

A 115VAC, 60 Hz, 15 Amp circuit breaker and electrical supply are required. A separate dedicated non-GFCI circuit, servicing only this appliance, is required.

Your Dacor® refrigerator is equipped with a 40” (1016mm) 3-prong grounded power cord, which must be plugged into a 3-prong grounding-type non-GFCI wall receptacle. Follow the National Electrical Code and local codes and ordinances when installing the receptacle. See “Rough-In Dimensions” for location of the electrical supply.

IMPORTANT: A ground fault circuit interrupter (GFCI) is not recommended and may cause interruption of operation.

Water Supply Requirements

◊All installations must meet local plumbing code requirements.

◊Connect to 1/4” (6mm) copper line to the house cold fresh water supply.

◊Use a shut off valve between the refrigerator and supply. The shut off valve should be a drilled saddle valve.

◊Do not use a self-tapping valve which reduces water flow and clogs more easily.

◊Allow a minimum of 24” (610mm) diameter service loop of copper tubing outside the wall or floor for easy connection to the water supply.

Cold water supply

Connect the ice maker to a cold water line with water pressure between 30 and 120 PSI. If you have any questions about your water pressure, call your utility company.

IMPORTANT:

◊In homes with a Reverse Osmosis water treatment system, remove the water inlet connector from the “yellow” valve and attached to the “blue” valve. Make sure the water filter bypass plug is in place.