Installation Instructions

Move Unit to Final Position

IMPORTANT: To prevent floor damage, make sure levelers are raised (not touching the floor) and the unit is on rollers before moving.

◊Place top of cardboard carton or plywood under refrigerator. Remove unit from dolly.

◊Move the refrigerator straight back and evenly into the rough opening. Verify that the water tubing is not kinked and the power cord is not kinked.

Leveling

CAUTION

To protect property and refrigerator from damage, observe the following:

•Protect vinyl or other flooring with cardboard, rugs, or other protective material.

•Do not use power tools when performing leveling procedure.

To enhance the appearance and maintain performance, the refrigerator should be level.

Note

Complete all electrical and water supply connections before leveling.

Materials Needed:

•3⁄8” hex head driver

•Carpenter’s level

1.Remove toe grille.

• Grasp firmly and pull outward to unclip.

2. Using hex head driver, turn the front adjustment screws (A) on each side to raise or lower the front of the refrigerator.

3. Using the hex head driver, turn each of these adjustment screws (B) to raise or lower the rear of the refrigerator.

4. Using the carpenter’s level, make sure front of refrigerator is 1⁄4” (6 mm) or 1⁄2 bubble higher than back of refrigerator and that the refrigerator is level from side to side.

5. Turn stabilizing legs (C) clockwise until firmly against floor.

6. Turn adjustment screws (A) counterclockwise to allow the full weight of the refrigerator to rest on the stabilizing legs.

7.Replace the toe grille.

•Align the toe grille mounting clips with the lower cabinet slots.

•Push the toe grille firmly until it snaps into place.

Installation Checklist

The importance of the proper installation of your Dacor Built-In Refrigerator cannot be overemphasized. Proper installation is the responsibility of the homeowner.

IMPORTANT: To ensure a safe and proper installation, the following checklist should be competed by the installer to ensure that no part of the installation has been overlooked.

Any questions or problems with this installations should be directed to your Dacor® dealer or the Dacor® Customer Service Department at 800.793.0093 or email customerservice@ dacorworld.com. You can also visit our website at dacor.com.

Are all leveling legs extended down to make contact with the floor? Is the unit level?

Is the power cord plugged into a properly grounded dedicated 3-prong non-GFCI outlet, which had been installed in accordance with all applicable electrical codes?

Is the water supply connected? Have you checked for leaks?

Has the kickplate been installed properly?

Have any installation/service problems been noted on the product registration card? Has the registration card been mailed?