Installation Instructions
Install Side Panel(s)
If the
IMPORTANT: Dacor is not responsible for customer installed molding or decorative panels that need to be removed or replaced to service the refrigerator.
1.For the inside side trim piece, slide the front edge of the routed side panel into the trim piece.
2.Nail the rear edge of the panel to the support board.
A
3. Snap the skirt onto the base grille.
A
B
A. Base grille
B. Skirt
4.Trim the skirt by scoring the proper “V” groove with a utility
knife. Break the skirt at the score line.
C
C. “V” groove
5.Using the two screws, attach the base grille assembly to the refrigerator as shown.
B
A.Support board (mounted to back wall)
B.Cab side trim
Install Base Grille
There are two pieces to the base grille to allow for a custom fit: the base grille itself and the skirt. The skirt can be added to the base grille in order to extend it all the way to the floor.
1.To see if the skirt is needed, place the base grille into position. Do not attach the base grille to the refrigerator. Measure the distance between the bottom of the base grille and the floor. The gap must be a minimum of ½” (1.27 cm) in order to add the skirt.
NOTE: If the gap measures less than ½” (1.27 cm), skip steps 3 and 4 of the instructions, and install the base grille only.
2. Remove the film from the base grille.
D
D.Screws (2)
6.Install the water filter and rotate it
20
