Dacor MCD227, MCD230, ECS130, ECD230, ECD227, ECS127, PCD230, MCS127, MCS130, PCS130 Mounting the Oven

Installation Instructions

C.Connecting the Green Appliance Wire to a Grounded Junction Box Wire or Grounded Cold Water Pipe – Where Local Codes Permit

1.Separate the green and white appliance wires.

2.Connect the black appliance wire to the black (L1) power supply wire in the junction box.

3.Connect the red appliance wire to the black (L2) power supply wire in the junction box.

4.Connect the red appliance wire to the red (L2) power supply wire in the junction box

5.Connect the green appliance wire to a grounded wire in the junction box or to a grounded cold water pipe.

6.If connecting to a grounded cold water pipe, a separate copper grounding wire (No. 10 minimum) must be connected to a grounded cold water pipe by means of a clamp and then to an external grounding connector screw.

WARNINGS

1.Do not ground the appliance to a gas supply pipe or hot water pipe.

2.Do not turn on power to the appliance until the oven is permanently grounded.

3.Grounded cold water pipe must have metal continuity to electrically ground and must not be interrupted by insulating materials. Any insulating materials must be jumped as shown below with a length of No. 4 copper wire securely clamped to bare metal at both ends.

	Cable from		Separate No. 10 (minimum)
power supply
			copper grounding wire
			Junction
			box		No. 4
					copper wire
					Meter
RED		WHITE
RED
		WHITE
GREEN		BLACK	Clamp must be
GREEN				Metal
		BLACK	tight on pipe
					Clamps
			Wire nut	water pipe
			(4 places)		Bare metal
Conduit from			Connecting the Appliance Ground to a Grounded Junction Box Wire or Cold Water Pipe.
	appliance

Mounting the Oven

WARNING

1.Failure to install the mounting screws may result in movement or tipping of the oven during use and personal injury.

2.Do not block the oven air exhaust located at the bottom of the oven. Blocking the intake may cause cabinet damage and poor baking performance.

Lift the wall oven up to the cabinet cutout, using the upper edge of the cavity opening and the bottom of the oven case side as gripping points. Use extreme caution when lifting the appliance as it is heavy. Be certain to take all necessary safety precautions.

Resting the oven on the cabinet-mounting platform, slide the oven into the recessed area until the rear edge of the oven frame is flush with the cabinet face and the oven is centered within the cutout. Ensure that the electrical conduit slides through the opening in the cabinet platform or coils above the oven chassis as the oven is slid into place. The cable must be placed into the recessed area located along the rear vertical edge of the oven or coiled above the oven chassis. Do not trap the appliance cable between the oven case back and the rear wall.

For the single ovens and the upper cavity of the double ovens, locate the mounting holes found in the sides of the oven frame. Using a 1/16” drill, drill four pilot holes for the #6 x 3/4” screws provided in the instruction envelope. Install the screws through the oven frame and into the cabinet to secure the oven. Do not over-tighten the screws.

Repeat the mounting procedure for the lower cavity if installing a double oven.

Oven Gripping Points

8