Installation Instructions
2.With the tank shelf open, connect the power cord from the outdoor grill and the warming oven (if equipped with one) to the electrical outlet on the back panel inside the cart.
Push to reset
Electical Outlet with Ground Fault Interrupter
3.Connect the rotisserie motor power cord to the electrical outlet on the back side of the cart.
Power Connection - Cabinet Installations
•Connect the appliance(s) to an electrical outlet that meets the specifications in the Planning the Installation section.
•The rotisserie motor should be plugged into the same outlet or an alternate 120 Vac outlet on the same circuit as the appliance.
Verifying Proper Operation
Lighting Instructions
1.Read and understand the accompanying use & care manual prior to cooking with this appliance. The use and care manual contains additional important safety, service and warranty information.
2.No adjustment of burner settings is required. All valves and air mixture shutters found in this appliance have been factory preset.
3.With the main gas supply valve on, turn all burner knobs to the HIGH position for approximately 20 seconds to allow the air in the system to purge from the grill and cooktop side burners.
4.Once the gas has filled the lines the automatic electronic ignition system should ignite the burner. If the system burners do not ignite within 20 seconds turn all burner controls to the OFF position. Wait five minutes and attempt the ignition process again.
5.Visually check the burner flame for proper operation. Proper flame operation will show a steady, soft blue color and stable flame.
6.If the second or third attempt to ignite the burner is not successful then turn all burner controls to the OFF position.
7.If the grill or cooktop fails to operate properly, ensure that the electrical power supply and gas supply are turned on and that all installation steps have been carefully followed. Check the ground fault interrupter(s) on the electrical outlet(s) to make sure that it is not tripped. Push the black button to reset.
8.If the grill still will not light, turn off the main gas line control valve or LP tank control valve and contact the Dacor Customer Service Team at (800)
Installation Checklist
warning
•To ensure a safe and proper installation, the following checklist should be completed by the installer to ensure that no part of the installation has been overlooked.
•Proper installation is the responsibility of the homeowner. The importance of proper installation of your Dacor Outdoor Grill cannot be over emphasized.
□Is the electrical outlet for the appliance grounded and located according to these instructions and in accordance with all applicable electrical codes for outdoor appliances?.
□Is the gas service for the appliance located and installed according to these instructions and in accordance with all applicable codes?
□Has the gas supply inlet pressure been measured to ensure that it does not exceed the maximums and meets the minimum stated in these instructions?
□Is the applaince secured to the cabinet or cart?
□Are the grease tray, flame spreaders, grates and, if applicable, burner heads and caps properly installed according to these instructions?
□Has proper operation been verified? Did the installer check the gas supply for leaks?
□Have any problems been noted on the warranty card or during the
17