Installation Instructions

Final Assembly and Test (cont.)

LP Cylinder Installation - Some Models

warning

•The largest recommended LP cylinder size for the rollout tank shelf on the cart is five gallons. A five gallon portable liquid propane cylinder should be approximately 12 inches (305mm) in diameter and

18 inches (457mm) high,. It must be constructed and marked in accordance with the specification for liquid propane (LP) gas cylinders of the U.S. Department of Transportation (DOT) and designed for use with a 5LP-A quick disconnect systems only.

•Cylinders must be stored outdoors in a well vented area out of the reach of children.

•On installations with a LP cylinder, when storing the appliance indoors, you must disconnect and store the LP cylinder outdoors.

•On models OB52 and OBS52, use only a two stage regulator on the gas supply line.

•For LP cylinder installations, the LP gas cylinder must have its own certified high-pressure regulator (Either Type I or No. 600 Connection).

•A dented or rusty LP tank may be hazardous and should be checked by your LP supplier.

•Never use a cylinder with a damaged valve.

•Do not change the regulator/hose assembly with a standard 510 POL tank/valve assembly.

•The cylinder must be provided with a shut-off valve terminating in a Liquid Propane (LP) gas supply cylinder valve outlet specified, as applicable, for connection No. 5LP-A.

•The cylinder supply system must be arranged for vapor withdrawal and provided with a listed overfilling prevention device.

1.For units that will use a LP cylinder, start by making sure the main valve is completely closed

2.Place the tank into the final position within the cabinet or cart.

 

Gas Connection at

 

Right Rear Corner

 

Under Outdoor Grill

 

Tank Gas

 

Regulator (included)

LP Tank Valve

Slideout LP Tank

Flexible Gas

Line (included)

Storage Shelf on

 

Optional Cart

 

 

LP Tank

 

(not included)

 

5 Gal Max.

 

Shelf Capacity

Leak Testing

warning

•Do not use a flame to check leaks.

•The grill or cooktop and shut-off valve must be disconnected from the gas supply piping during any pressure testing exceeding 1/2 psi (3.5kPA).

1.Turn all burner control valves on the front of the appliance to the “OFF” position.

2.With the power to the appliance DISCONNECTED, turn on the main gas supply valve.

3.Check all gas connections for leaks using an electronic gas leak detector. You may also apply a water and soap solution to the connections. Bubbles around the connections indicate a leak. If you observe leakage do not attempt to operate the appliance until all leaks have been eliminated.

Power Connection - Cart Models

1.If the appliance is installed on a cart, connect a three- prong extension cord (minimum 5 Amp. capacity) to the power input on the back of the cart. Connect the extension cord to a grounded, three-prong, electrical outlet.

16