Installation Instructions

Hanging the Blower Assembly

warning

•Do not use screws to attach the duct work to the exhaust outlet. Use duct tape only. Screws may prevent the damper flaps on the top of the hood from opening.

1.Inside the exhaust outlet on the top of the blower assembly, there are metal or plastic damper flaps. The flaps close to help prevent back-drafts when the blower is turned off. Remove the shipping tape and make sure the flaps open and close freely before proceeding.

exhaust outlet

2.Lift the blower assembly up and put the mounting hole on the top over the mounting bracket, while inserting the exhaust outlet into the end of the duct system. Gently lower the blower assembly onto the lip of the mounting bracket. Slide the bottom part of the blower assembly between the two “L” brackets.

insert EXHAUST

OUTLET INTO

END OF DUCT

MOUNTING

BRACKET

3.Insert two provided machine screws into the two holes above the mounting bracket on the blower assembly and tighten into place.

4.Insert two machine screws through the front of the mounting bracket and tighten into place.

5.Insert two machine screws through the side of both “L” brackets and tighten into place.

6.Attach the end of the duct system to the exhaust outlet with duct tape.

“L” BRACKETS