Installation Instructions
Chimney Installation (cont.)
5.Carefully put the chimney over the blower assembly, taking care not to scratch the surfaces. Make sure the wiring is tucked in behind the chimney.
6.Lock the tabs inside the chimney bottom into the slots on the bottom of the blower assembly.
slots
tabs on
INSIDE OF
chimney
Lock tabs on INSIDE OF chimney into slots
on blower assembly
7.Slide the top of the chimney up toward the ceiling. Line up the holes on the side of the chimney, near the vents, with the holes on the side of the chimney mounting bracket.
8.Attach the top of the chimney to the mounting bracket using two sheet metal screws, one on each side.
chimney mounting bracket
Install the Hood
warning
•Attaching the glass range hood requires two people. Do not attempt to lift the hood without assistance.
1.Locate the hood mounting hardware. It consists of:
-4 thumb screws
-4 plastic washers
-4 plastic spacers
2.For easier hood installation, assemble all the thumb screw hardware before lifting the hood into position.
•Hold each thumb screw with the threads up.
•Put the plastic washer on the thumb screw.
•Put the plastic spacer over the end.
3.Lift the glass hood into place. Line up the holes on the glass with the mounting holes on the bottom of the blower assembly.
4.Insert all four thumb screws into the bottom of the glass and tighten into place.
CHIMNEY
10